I have the opportunity to pick up a Shopsmith for a steal. Has anyone used a Shopsmith to make pipes? Looks like a great machine with the lathe and drill press built in, along with a sanding disk and table saw. I'm just not that familiar with the tool.
Can you guys give me some advice?
Shopsmith question
- LexKY_Pipe
- Posts: 875
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Lexington, Kentucky USA
YES, that is what I use. I do not use it as a lathe. I do all my drilling on it, buffing, and shaping on it. I made a plate and mounted a self-centering
vise on the tail end and therefore there is no need to stand it up in order to do my drilling. I use it as a horazontal (?) boriing tool. It was been working great for the last five years.
vise on the tail end and therefore there is no need to stand it up in order to do my drilling. I use it as a horazontal (?) boriing tool. It was been working great for the last five years.
- LexKY_Pipe
- Posts: 875
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Lexington, Kentucky USA
Kirk
Thanks. Would you mind posting a photo or emailing a photo to me of the plate that you made for the self-centering vise.
loscalzo@iglou.com
Thanks
Thanks. Would you mind posting a photo or emailing a photo to me of the plate that you made for the self-centering vise.
loscalzo@iglou.com
Thanks
-
- Posts: 142
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Great Lake State
- Contact:
yes i do use a shopsmith and it works great. i only use it to drill the bowl and draft hole, i do convert it to a drill press, after i drill the draft hole with it in the boring machine configuration, to drill the bowl in the drill press mode.
It doesnt take long at all to covert it as random mentioned, it takes me maybe under 30 seconds to convert it from a boring machie to drill press. Your not changing anything but the configuration of the machine thats all. i also have a bandsaw attachment for mine, and use it as such after drill the bowl out. that takes maybe 30 seconds tops.
It works good and is very reliable, havent had any problems with mine at all. once it is squared up it works like a dream and is very fast.
It doesnt take long at all to covert it as random mentioned, it takes me maybe under 30 seconds to convert it from a boring machie to drill press. Your not changing anything but the configuration of the machine thats all. i also have a bandsaw attachment for mine, and use it as such after drill the bowl out. that takes maybe 30 seconds tops.
It works good and is very reliable, havent had any problems with mine at all. once it is squared up it works like a dream and is very fast.