Any suggestions on adding initials on the side of a black stem.
The initials wanted would be white... I am guessing that if one places some type of white material over the stem and then imprints the initials with steel lettering that the material will be imbedded in the lettering.
But what material could one use?
What other ways can white initials be added to a stem??
I use white acrylic (water base) paint. You don't have to be careful about where it goes, since you lightly sand it, when it's dry, to remove any that isn't inside the imprint. After buffing it stands out crisp and white against the black.
Regards,
Frank.
------------------
Grouch Happens!
People usually get the gods they deserve - Terry Pratchett