Have been thinking about adding real "wood turning capabilities" to my process...
Any of you out there using both a metal lathe (for drilling) and a wood lathe (for shaping) or using a tool rest for turning tools on the metal lathe?
Would love to hear about your set-up or workflow.
I know some are putting a steel bar into the tool holder of the metal lathe as tool rest... I'd love to see it.
If you're switching lathes in the process, how do you keep everything centered? Do you re-chuck the stummel or use only one chuck on both lathes etc.?
Thanks!
Switching lathes…
-
- Posts: 21
- Joined: Tue May 11, 2021 4:45 am
- Contact:
Re: Switching lathes…
I've mainly used a long carbide turning tool in my multifix tool holder as a tool rest for a small wood turning chisel. It's not safe, but it works.
The easiest way to switch lathes if you wanted to (though it's probably a bad idea), is to either ensure both lathes have the same headstock thread so you can screw the chuck onto both, or to clamp your wood turning chuck in the metal lathe's 3 jaw by it's thread adapter (if it has one, like the oneway chucks).
rechucking your stummel will ALWAYS cause alignment issues, however small.
The easiest way to switch lathes if you wanted to (though it's probably a bad idea), is to either ensure both lathes have the same headstock thread so you can screw the chuck onto both, or to clamp your wood turning chuck in the metal lathe's 3 jaw by it's thread adapter (if it has one, like the oneway chucks).
rechucking your stummel will ALWAYS cause alignment issues, however small.
Website: http://www.massispipes.com
Instagram : http://instagram.com/massispipes
Twitter: https://twitter.com/MassisPipes
Facebook: https://facebook.com/MassisPipes
Instagram : http://instagram.com/massispipes
Twitter: https://twitter.com/MassisPipes
Facebook: https://facebook.com/MassisPipes
-
- Posts: 21
- Joined: Tue May 11, 2021 4:45 am
- Contact:
Re: Switching lathes…
Thanks Massis! I've found a tool rest specifically for my multifix holder. I'll start with that one and see how it works!