bulldog particulars
bulldog particulars
I just got my bulldog kit from Tim West and and am very excited to get started. Before I start working on this sucker I was wondering if there are specific dimentions for the bulldog ? It's going to be a 1/4 bent beyond that I am open to sugestions. Thanks for the help.
It's better to keep your mouth shut and be thought a fool than to open it and remove all doubt.
Re: bulldog particulars
Hi Dozuki,
if you are able to read German (or translate it with goolge) I've created a big dokumentation about pipe shapes.
Here is the documentation about the bulldog: http://www.daskunstportal.at/pipemaker/ ... =85&t=1461
And here an overview (look the area "Die Familie der Rhodesianähnlichen" means "the family of the rhodesians") http://www.daskunstportal.at/pipemaker/ ... =85&t=1390
Hope that help.
Greetings from Graz
Peter
if you are able to read German (or translate it with goolge) I've created a big dokumentation about pipe shapes.
Here is the documentation about the bulldog: http://www.daskunstportal.at/pipemaker/ ... =85&t=1461
And here an overview (look the area "Die Familie der Rhodesianähnlichen" means "the family of the rhodesians") http://www.daskunstportal.at/pipemaker/ ... =85&t=1390
Hope that help.
Greetings from Graz
Peter
Pipe-Blog: http://daskunstportal.at/artofbriar/
Drawing-Blog: http://daskunstportal.at/8bar/
Forum: http://www.daskunstportal.at/pipemaker/index.php
Drawing-Blog: http://daskunstportal.at/8bar/
Forum: http://www.daskunstportal.at/pipemaker/index.php
Re: bulldog particulars
I asked nearly the same question when I started my first bulldog. Sas had some good advice. Here is the link to that post:
viewtopic.php?f=9&t=6566
viewtopic.php?f=9&t=6566