pipemakersforum.com

Good Evening-

I understand I am not regular poster on this board.
I do have some high quality pipe making tools at special prices for the CORPS Show in Richmond, and celebrating 10 years in business online.
I thought it would be good to share with this group and show my appreciation to the profession.
Can you buy less expensive tools, of course my customer base has evolved to the top pipesmiths in the world.
You buy my tools only once if you take proper care they should last you forever. I service all my products myself for as long as I am physically able and many in the business can attest to my service.
Please visit my tooling page and have a look.

As always 100% satisfaction and service.
Thank you in advance for looking, Happy smoking,

Ken Lamb / Proprietor
http://www.LambPipes.com

Good Evening-
Tooling update, chucks are thru the lathe and rough mill OP. On schedule for End of September.
Spoon bits are going to heat-treat on Monday 9-19, two days then finish relief grind, protective finish, packaging.
I am a little ahead of schedule on the spoon bits.
S&D tobacco chamber bits are purchased and will be setting up for profile grind on Tuesday 9-20-2011.
Will advise.
Thank you for looking,
Ken
http://www.lambpipes.com

Update!
http://www.lambpipes.com/pipemakingtools.htm

Thank you for looking!

Good Evening-

I am all packed and porduct is shipped to the Hilton in dowtown Richmond.
Flying in Friday morning.
No more sales until after I return.
If you are going to the CORPS Expo please stop by and say hello.

Happy smoking,

Ken