deep cleaning and polishing a sandblast
-
- Posts: 2
- Joined: Tue Feb 02, 2010 5:43 pm
deep cleaning and polishing a sandblast
What do you guys recommend for deep cleaning and polishing a sandblast? I picked up an estate and its filthy and I want to clean it up. I have a buffer but that isn't going to work to clean it. Any tips or tricks?
Re: deep cleaning and polishing a sandblast
I know this mite sound a little out of the norm But I have been using Mr Clean Magic Eraser (original) to clean up bits that have oxidation. and on top of pipe it removes smoke build up, Caution it will dull finish. So just buff and should be fine
Don't tell anyone I'm keeping it a Secret
I forgot wet the eraser a little it works better
Don't tell anyone I'm keeping it a Secret
I forgot wet the eraser a little it works better
Re: deep cleaning and polishing a sandblast
A lot depends on how much you want to do to the pipe, if you just want to clean the surface before re-waxing then use an old tooth brush and warm water, in most cases it will leave the original finish intact.
If you want to re-finish the pipe (dye, polish,wax) then use alcohol of some type to remove the old finish and whatever is on the surface, this works well on the rim where the alcohol helps soften the cake. Re-apply the dye in thin layers ensuring that each is dry before the next goes on, you then have a choice between a shellac coat/finish or straight to wax finish.
David
If you want to re-finish the pipe (dye, polish,wax) then use alcohol of some type to remove the old finish and whatever is on the surface, this works well on the rim where the alcohol helps soften the cake. Re-apply the dye in thin layers ensuring that each is dry before the next goes on, you then have a choice between a shellac coat/finish or straight to wax finish.
David
-
- Posts: 2
- Joined: Tue Feb 02, 2010 5:43 pm
Re: deep cleaning and polishing a sandblast
Thanks David! I'll try the warm water and toothbrush route.
Re: deep cleaning and polishing a sandblast
I was spray painting in my shop, and left a pipe in a location where it got some overspray.
I dipped a toothbrush in lacquer thinner, and kind of sprayed it off, then went after the pipe. It worked really well and didn't affect the finish much, which makes me think the pipe is shellac'd.
I dipped a toothbrush in lacquer thinner, and kind of sprayed it off, then went after the pipe. It worked really well and didn't affect the finish much, which makes me think the pipe is shellac'd.
ALL YOUR PIPE ARE BELONG TO US!
Re: deep cleaning and polishing a sandblast
I cleaned up a few estates w/ a nylon bristle dremel attachment at low speed. Worked great for me.
The tooth brush does sound a little safer though.
The tooth brush does sound a little safer though.