pipemakersforum.com

Question fellas,

I have use Kurts french arbor and sanding pads (love the setup by the way) but would like to try these Abralon sanding pads. I can only find them in 3" and 6". If I want to use these on my 5" pipecrafter sanding pad, do I just get the 6"ers and let them over hand .5? or is my only choice to find a new way to mount to my motor?

Thanks.

Get the 6" and let 'em hang. They're much more usable that way, allowing the edge to flex like so.

Im always a fan of letting em hang in any circumstance.

SimeonTurner wrote:Im always a fan of letting em hang in any circumstance.

And flex too. Don't forget the flexing!