This pipe was made from a pre-drilled ebachon kit with a bent stem that I found on ebay. It's not an ideal piece of wood, but I think it turned out ok. I hand carved the briar and trim cut the stem to match. I have not set up much of a shop area yet, so all was done with a coping saw, rasps, and sandpaper. I've since added a Dremel, and am setting up a buffing station this weekend for a better finishing process.
Any feedback would be more than welcomed.
![Image](http://i36.photobucket.com/albums/e10/ashlea30/108_3411.jpg)
![Image](http://i36.photobucket.com/albums/e10/ashlea30/108_3412.jpg)
![Image](http://i36.photobucket.com/albums/e10/ashlea30/108_3479.jpg)