ON HOLD...

What to buy a used tool? Looking to sell some extra stems or inlay material? Post your buy, sell, or trade requests and advertisements here.
Post Reply
User avatar
JSPipes
Posts: 255
Joined: Thu Nov 23, 2006 8:00 pm
Location: Rancho Cordova, CA
Contact:

ON HOLD...

Post by JSPipes »

On hold for a bit pending another issue....
Last edited by JSPipes on Mon Mar 27, 2006 5:46 pm, edited 2 times in total.
User avatar
Tyler
Site Supporter
Posts: 2376
Joined: Thu Nov 23, 2006 8:00 pm
Location: Farmersville, TX
Contact:

Post by Tyler »

Oh man, I've wanted one of those...tempting, tempting.

Tyler
User avatar
JSPipes
Posts: 255
Joined: Thu Nov 23, 2006 8:00 pm
Location: Rancho Cordova, CA
Contact:

Post by JSPipes »

Make me an offer Tyler! I'm going a different route altogether and need to raise the money to pay for it.

Joel
User avatar
Tyler
Site Supporter
Posts: 2376
Joined: Thu Nov 23, 2006 8:00 pm
Location: Farmersville, TX
Contact:

Post by Tyler »

I just don't have the coin. If I were still selling pipes, I'd by it in a blink, but with no pipe cash flow I can't.

Sorry!

I'm more bummed than you about it, I promise.

Tyler
User avatar
JSPipes
Posts: 255
Joined: Thu Nov 23, 2006 8:00 pm
Location: Rancho Cordova, CA
Contact:

Post by JSPipes »

Blast! Ok. Ya know, I'd trade for briar and stem stock ;-)

Joel
User avatar
Tyler
Site Supporter
Posts: 2376
Joined: Thu Nov 23, 2006 8:00 pm
Location: Farmersville, TX
Contact:

Post by Tyler »

Hmm...

I only have 4 blocks of briar, but I did keep a little stash of rod stock. I don't know how much I'd be willing to part with, but I'll look tonight and see. Maybe a combination of supplies and cash?

If you have a cash offers in the meantime, feel free to jump on it. It's still unlikely that I'll be able to swing it...but I'll check!
User avatar
JSPipes
Posts: 255
Joined: Thu Nov 23, 2006 8:00 pm
Location: Rancho Cordova, CA
Contact:

Post by JSPipes »

Supplies and cash would work. I would have to buy the supplies anyway, so it works out the same. I'm even willing to go whatever Pipe Makers Emporium is currently selling the supplies for.
User avatar
Tyler
Site Supporter
Posts: 2376
Joined: Thu Nov 23, 2006 8:00 pm
Location: Farmersville, TX
Contact:

Post by Tyler »

I looked my stash over and I'm not going to be able to swing it. It would take almost all of my rod, and I'd rather have the rod at this point.

Dang.

Tyler
User avatar
JSPipes
Posts: 255
Joined: Thu Nov 23, 2006 8:00 pm
Location: Rancho Cordova, CA
Contact:

Post by JSPipes »

Well, with the amount of interest I've gotten, I might be sitting on this chuck for a while. Might take it to the LA show and ask around there too.

Joel
Post Reply