Janka hardness for briar
Janka hardness for briar
I ran accross a hardness scale for wood the other day called the Janka scale. Are any of you familiar with it? Apparantly it is a measurement of the force required to drive a .444" steel ball 1/2 an inch into the wood. There were some woods I saw that measured in the 3000 range. Does anyone know what is the Janka rating for briar?
- Tyler
- Site Supporter
- Posts: 2376
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Farmersville, TX
- Contact:
I have no idea, but I'd certainly be interested to know!
Tyler
Tyler
Tyler Lane Pipes
http://www.tylerlanepipes.com
http://www.tylerlanepipes.com
Just saw some one post this on ASP.
Briar Erica arborea 960-1138 (sometimes seen it at 2000)
Cool information, but I'm surprised the number isn't higher. The other measurment for wood's hardness it specific gravity. Doesn't acually measure hardness, rather density. Perhaps briar isn't all that hard, but very dense. That would make sense really; not so hard as to make it aweful to work with, but dense enough to withstand the heat.
I should be getting info from the Forestry service about briar soon. I'll post it as soon as I receive it.
Briar Erica arborea 960-1138 (sometimes seen it at 2000)
Cool information, but I'm surprised the number isn't higher. The other measurment for wood's hardness it specific gravity. Doesn't acually measure hardness, rather density. Perhaps briar isn't all that hard, but very dense. That would make sense really; not so hard as to make it aweful to work with, but dense enough to withstand the heat.
I should be getting info from the Forestry service about briar soon. I'll post it as soon as I receive it.