Page 1 of 1
Correcting a Pipe's Manufacturing Errors 2 -- (video set)
Posted: Wed Jun 10, 2020 6:44 pm
by LatakiaLover
#1 was a Dunhill Redbark 848 ODA, this time the patient is an Ashton Sovereign panel:
https://www.youtube.com/playlist?list=P ... D-zUz7tj33
Re: Correcting a Pipe's Manufacturing Errors 2 -- (video set)
Posted: Thu Jun 11, 2020 3:22 am
by Flygare
It is always a joy to watch your videos George. Even if I dont do repairs I learn a new trick or two every time that can be used in pipemaking or other tinkering in the workshop. Thank you for making them and for sharing your knowledge!
Skickat från min iPhone med Tapatalk
Re: Correcting a Pipe's Manufacturing Errors 2 -- (video set)
Posted: Fri Jun 12, 2020 1:45 am
by seamonster
One question about shank taper:
In the video you talked about the barrel of the saddle having a slight outward flare.
Do you think this same applies to a looooong shanked lovat, or similar? Or would the taper from bowl down the shank
continue through the barrel (assuming saddle stem) and then the blade starts to flare at the point of radius?
Different for a square shank vs. a round shank?
I guess looking at this picture, the barrel begins to flare a bit? Bad example?
Re: Correcting a Pipe's Manufacturing Errors 2 -- (video set)
Posted: Fri Jun 12, 2020 2:56 am
by caskwith
I think that one might have been made after Bill's liquid lunch.