Page 1 of 1
Rawkrafted Tapered Bits
Posted: Sat May 02, 2020 8:24 am
by alexnc
Hi - I saw these referenced in a few posts. Revealing I'm a noob, but would these fit a 1/2" drill press chuck? They look pretty awesome but I'm latheless as yet
https://rawkrafted.com/tools/chamber-dr ... ull-taper/
Re: Rawkrafted Tapered Bits
Posted: Sat May 02, 2020 9:42 am
by alexnc
They responded yes, it will fit a 1/2" chuck
Re: Rawkrafted Tapered Bits
Posted: Mon May 04, 2020 3:50 pm
by seamonster
Yup, I've got a few of those in different shapes and sizes, and they work great..... I've got 20 to 30 pipes on them and still cutting ribbons. Can't speak to where they'll be after a few hundred....
Sent from my bloopty-bloop, using hooty-hoo.