Page 1 of 1
Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 11:19 am
by kasperbunk
Hallo guys. Any advice on making a handle or something to hold the numbering stamps. Mine are squere and a pain to control in my bare hands. How do you guys do?
Sent from my iPhone using Tapatalk
Re: Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 1:53 pm
by sandahlpipe
I use my bare hands... but if it were bothering me, I’d just drill a hole in a scrap of wood and make a handle out of that.
Sent from my iPhone using Tapatalk
Re: Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 1:58 pm
by LatakiaLover
Old billiard ball + drill bit + epoxy = comfort (also greater "delivery pressure" potential)
Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 2:36 pm
by kasperbunk
I was looking for something where I can change numbers but it is hard to drill a squere hole:-(
Sent from my iPhone using Tapatalk
Re: Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 2:46 pm
by LatakiaLover
No square hole needed.
And if you don't want to glue the stamps into the ball---epoxy will fill the gaps just fine, btw---then use something like this to hold them in while still being switchable:
https://www.amazon.com/Putty-Re-useable ... way&sr=8-2
Re: Numbering stamp handle/holder
Posted: Mon Sep 09, 2019 4:45 pm
by caskwith
Golf balls make great tool handles, I use them for all sorts, especially lathe files, super safe for that.