PITH practice 2019
Posted: Sun May 19, 2019 5:21 pm
Hello All,
I hope everyone’s recovered from the Chicago pipe show. This is another attempt at a billiard. I tried to incorporate all the feedback I was given in my previous post while adhering to the PITH rules. I’m still struggling with the stem/shank junction. I used the countersink tool from Rawcrafted, so I know the mortise is square. I used Pimo’s tenon turning tool on an entry-level drill press for the tenon. Is there a trick to getting a flush fit after the fact? I tried various manners of placing sandpaper in between. Perhaps I gave up to soon, but the results weren’t satisfactory. Any guidance would be appreciated.
Sent from my iPhone using Tapatalk
I hope everyone’s recovered from the Chicago pipe show. This is another attempt at a billiard. I tried to incorporate all the feedback I was given in my previous post while adhering to the PITH rules. I’m still struggling with the stem/shank junction. I used the countersink tool from Rawcrafted, so I know the mortise is square. I used Pimo’s tenon turning tool on an entry-level drill press for the tenon. Is there a trick to getting a flush fit after the fact? I tried various manners of placing sandpaper in between. Perhaps I gave up to soon, but the results weren’t satisfactory. Any guidance would be appreciated.
Sent from my iPhone using Tapatalk