Page 1 of 1
RC Volcano stem
Posted: Mon Mar 11, 2019 11:04 pm
by Doug535
How am I doing so far, inasmuch as the blade shaping? Any tips on a fairly quick way to get the top and bottom radii? I used my pippin file, painfully slow process.
https://imgur.com/a/3eebdlS
Re: RC Volcano stem
Posted: Tue Mar 12, 2019 2:48 pm
by DocAitch
I think it looks good. I also use pippins for that area, then flats on the blade.
I go into a sort of Zen state while working like that, and the process is less painful.
DocAitch
Re: RC Volcano stem
Posted: Sat Mar 16, 2019 11:48 am
by Doug535
DocAitch wrote:I think it looks good. I also use pippins for that area, then flats on the blade.
I go into a sort of Zen state while working like that, and the process is less painful.
DocAitch
Yea Doc, you almost gotta zone out somehow, in order to get through it. I may need to grab a coarser pippin to help in quicker removal.