Page 1 of 1
How Long Does it Take You to Make a Pipe
Posted: Wed Jul 27, 2005 5:21 pm
by Progcat
Hello Everyone,
Just curious, how long does it take for others to make a pipe from start to finish. I'm not in any hurry whatsoever, but it takes me at least eight hours (and sometimes more) to finish one including the stem.
Progcat@msn.com
Posted: Wed Jul 27, 2005 8:24 pm
by bscofield
I'm not handcutting my stems yet, but it takes me about 4 hours all combined. But I rarely do that in one sitting.
Posted: Wed Jul 27, 2005 9:22 pm
by marks
I don't really track time, but I spend at least ten hours, spread over one to two months as I get an hour or two to work on one. I do a lot of shaping by hand with files, sandpaper, and occasionally pocket knives (for instance, the ridge around the front of the edge of pipe 1805 I cut with a knife
). I handcut stems on all my pipes.
Posted: Thu Jul 28, 2005 2:49 am
by StephenDownie
A minimum of between 8 and 12 hours per pipe. I cut all my own stems and do a lot of shank extensions though.
Posted: Thu Jul 28, 2005 2:20 pm
by ArtGuy
I would say maybe 3 to 4 sittings of 3 to 4 hours each. All of my stems are handcut.
Posted: Thu Jul 28, 2005 10:27 pm
by bscofield
John! Where the hell you been!? :think:
Posted: Fri Jul 29, 2005 2:16 pm
by KurtHuhn
That depends.
Some pipes take me about 1.5 to 2 hours start to finish. Other pipes take much longer depending on stem material, shank extensions, and finish type. The most I ever spent was about 8 hours total on a special order. That pipe gave me a load of trouble.
Regardless of how much total time it takes me, it typically take about 2 weeks to get a completed pipe finished. I let the wood rest after boring and rough shaping.
Posted: Fri Jul 29, 2005 4:44 pm
by RadDavis
Hi Kurt,
What's your reason for letting the wood rest after rough shaping?
Rad
Posted: Fri Jul 29, 2005 11:49 pm
by KurtHuhn
Well, just my own set of prejudices that I developed after 20-something years of working with wood. Wood needs to acclimate itself, and I figure "what can it hurt". I don't know if it helps, but it sure isn't hurting.
What I hope to gain is a pipe that takes a smooth finish much better than one that hasn't rested. I figure, with the wood rough shaped and drilled, there's still moisture to be released, and I want to give it the time to leave.
Crazy and wacko? Maybe....
Posted: Sat Jul 30, 2005 3:41 am
by StephenDownie
Kurt,
I try to leave the drilled block for a good month or two as well. My reasoning is the same as yours. Get the last bit of moisture out of the heart of the block. I usually leave them in a sunlit window. The only possible exceptions are for special orders when the customer wants the Pipe ASAP and then I use a moisture meter to make sure all is well before sending it off..