Shaping tools
-
- Posts: 112
- Joined: Wed Aug 12, 2015 9:42 pm
- Location: Galax, Virginia
- Contact:
Shaping tools
I was wondering if anyone here regularly uses something other than a sanding disk for initial shaping? I was researching alex florovs work and read that he primarily uses chisels for shaping. I just wanted to get a little insight into some other good tools for shaping more ornate pieces.
Re: Shaping tools
I did my first few pipes using a Dremel with a sanding drum bit. Works fine, but you do get absolutely covered in briar dust.
Ryan Richardson
R2 Pipes/Ryan's Luxury Goods
______________________________________
"You can't convince a stupid person that what he's doing is stupid, because the stupidness inside him is telling him that it's smart"
R2 Pipes/Ryan's Luxury Goods
______________________________________
"You can't convince a stupid person that what he's doing is stupid, because the stupidness inside him is telling him that it's smart"
- sandahlpipe
- Posts: 2106
- Joined: Mon Feb 04, 2013 8:49 pm
- Location: Zimmerman, MN
- Contact:
Re: Shaping tools
I usually start with a 36 grit disc and then use an 80 or 120 grit belt on my 1" belt sander. I then use a combination of my slack belt sander, a 400 grit french wheel, and various files to fine tune the shape. I rough in the stems on the belt sander for the most part. I've used chisels and knives for some detail work, but it's not part of my usual process. Bottom line: use what you have available to you.
- mightysmurf8201
- Posts: 712
- Joined: Sat Jan 07, 2012 12:44 pm
- Location: Hudson, OH
- Contact:
Re: Shaping tools
This is important. Regardless of what your current setup is, there is no substitute for getting pipes under your belt. That being said, here's my method. Everyone is different, some drastically so. I turn what I can on the lathe while drilling. 40 grit wheel for shaping, 120 wheel for fine tuning, 220 wheel for getting scratches out and some fine tuning, then hand sanding from there. I'm in the process of adding a 320 wheel. There's usually about 5 minutes or less, if any, of file work to clean up transition points, usually before the 220 wheel. 1" belt sander to rough in stems, and fine tune with files before sanding.sandahlpipe wrote: Bottom line: use what you have available to you.