Page 1 of 1

attemt to put a pipe in vision for all

Posted: Wed Jun 01, 2005 7:31 am
by smokepiper
Image

wow!

Posted: Wed Jun 01, 2005 7:36 am
by smokepiper
I did it, my dusty briarbrain made a progress. This i a cause fore a salubration with a picnic by the lake and great tobaccos just feel alright. Until the damned mosquitos gets to feel my blood in their long nose. :angel:

Posted: Wed Jun 01, 2005 8:20 am
by Nick
That's pretty cool buddy. The length looks a bit awkward, but its hard to tell from the angle. The stem fit needs a bit of work. What kind of wood did you use for the extension?

reply the cobra

Posted: Wed Jun 01, 2005 8:32 am
by smokepiper
the extention is cumberland the picture is´nt the best I can look for a better and post it here. I haven´t worked on it cause i detected spots that should ruin the shape if i were to sand it of. Thanks for your positive reaction to my logopipe, about to be logopipe. Next one is for the better wood, waiting for briar from Mimmo that probobly will make me a cobra worth to be a logotype. Have to make a few new pictures of the cobra, look it up tomorrow and I´m sure i posted a new picture.

Posted: Wed Jun 01, 2005 11:07 am
by LexKY_Pipe
I like the "cobra" look, or is that just my imagination?

cobra

Posted: Wed Jun 01, 2005 11:26 am
by smokepiper
Image

Posted: Wed Jun 01, 2005 3:04 pm
by Nick
Very cool from the profile. Can't wait to see the next one.

cobra

Posted: Thu Jun 02, 2005 1:55 am
by smokepiper
I thank you both for the nice words of my pipe, it gives me a push to keep my imagination be a part of what I do. I brought a few pipes to the meeting here in sweden were Tukotomi, Nordh, Bengt Carlson, Dura, Vollmer-Nilsson, Love and Tom Eltang attended aswell. I showed 4 of my pipes and got correction for 3 of them (I am a newbi so It was my thought from the beginning to get some advice from them) the 4:th was my first cobra and noone gave it correction. My head turned to a weatherballon and didn´t returned for a week or so, even Bo Nordh thought the shape was OK! My intention now is to make a spotless and nicegrained cobra to make my logotype, It´s a block that is cut to make a horn. Now I need all knowledge there is cause I have been granted a education in pipemaking(I have a topic on that in this forum), and my thoughts is for others to share my experienses through my education. Please read the topic and we might do something out of the ordinary for everyone in this forum.