Page 1 of 1
I need vulcanite rod
Posted: Fri May 27, 2005 10:41 am
by ScoJo
Is anyone selling any? Where should I look? I am obsessed with a pipe I found online that I would like to try to recreate (I know it won't look the same, but I'm going to try). Problem is it has a hand-turned stem and a triangular shank. I guess I've resigned myself that this cannot be done with one of my pre-formed stems...
Posted: Fri May 27, 2005 12:09 pm
by bscofield
Scott, that guy that sold us our drill bits told me he had vulcanite. You could give him a try and see if he does or not. Let me know what you find out too...
Posted: Fri May 27, 2005 1:05 pm
by KurtHuhn
I'll have some I can spare in a week or so. If you're still looking, ping me then.
Posted: Fri May 27, 2005 2:36 pm
by Tyler
Scott,
I've seen the pipe of which you speak, and I'd bet a dollar it is a preformed stem. I've seen stems exactly like that. Not to disuade you from your hand-cutting efforts, but it is not absoutely necessary in this case.
Tyler
Re: I need vulcanite rod
Posted: Sat May 28, 2005 10:34 am
by bscofield
ScoJo wrote:I am obsessed with a pipe I found online
Tyler wrote:I've seen the pipe of which you speak
Secrets, secrets are no fun. Secrets, secrets hurt someone!
What's the pipe!?
Posted: Sun May 29, 2005 2:14 pm
by LexKY_Pipe
Let's see the picture?