Page 1 of 1

Dubdog...

Posted: Thu Jan 29, 2015 2:27 am
by JMG
Not happy with this one, but it feels good to have my first diamond shank behind me...they are a pain in the butt. Was trying for a bulldog, turned more into a Dublin with a hat.

Things I think could be better: 1. The shank line carries into the bowl too much. Looking at it now I wish I would have ended where the shank enters into the bowl more in line with line of of bowl (if that makes any sense. 2. I wish my angles on the shank were at 45 degrees...they are no wear close. 3. I took too much off the bowl right above the shank. 4. didn't mean to angle the bottom part of the bowl so much. Actually, meant it to be more rounded, but I am still learning my way around a lathe.

Ok...anything else you guys see?

Image

Image

Image

One flaw...bummer.
Image

Image

Re: Dubdog...

Posted: Thu Jan 29, 2015 6:36 am
by taharris
I agree, you missed the Bulldog shape, but you did do a lot of things right on this pipe.

Your lines are nice and sharp. I wouldn't be ashamed to smoke this pipe in public.

Two critiques:

Rounding the profile of the bowl (instead of straight lines) would have created the Bulldog shape you were after.

Also, the saddle in your saddle stem is too gradual. Aim for almost 90 degrees.

Todd

Re: Dubdog...

Posted: Thu Jan 29, 2015 9:01 am
by scotties22
I think Todd covered most everything. I will say I love the way you got the band-aid on your finger to match the color of the pipe :lol:

Re: Dubdog...

Posted: Thu Jan 29, 2015 11:26 am
by wdteipen
The only other thing I see is that the bowl appears to angle back towards the stem. I'm guessing it doesn't really and that it's an illusion of the shape. A slight bend in the stem would help counter the illusion. I like the shape and think it's worthy of being a signature shape with a few minor refinements.

Re: Dubdog...

Posted: Tue Feb 03, 2015 11:57 am
by i.keenum
Looks good , quite different but not a bad thing at all. Keep up the good work.