Thanks for looking.
-Pat
The button is still too thick. Get yourself a dial caliper and don't settle for anything less than 4mm behind the button. If you can't get the button thinner, make sure you're drilling the slot with a 1/16" drill bit for the last inch or so of the stem and funnel to the sides.RiverWader wrote:The button on this is so thin I can't do anymore without breaking into the air hole area.
I promise I'm not trying to be a jerk, but what does this mean? If you don't properly complete a project, what do you hope to gain from doing the next one? Put another way, if you do not put the effort into e.g. finishing the stem, you will learn nothing about finishing stems.RiverWader wrote: For me, I'd reached a point that it was just time to take my learnings and move on.