sanding the bowl

Nick · Post by **Nick** » Wed Feb 02, 2005 9:07 am

I'm afraid I can't see the tool too well. How does it work?

achduliebe · Post by **achduliebe** » Wed Feb 02, 2005 9:14 am

That looks like a souped-up coffee frother. That gives me some ideas....hmmmm

CigarBoB · Post by **CigarBoB** » Wed Feb 02, 2005 10:40 am

Brendhain this s the leading manufacturer of bowling ball drill bits. It may be possible to drill a pipe bowl with them. I would doubt they will cut very well. A bowling ball is surprisingly soft compared to a Brier pipe. IMO but i could be wrong.
http://www.jayhawkbowling.com/Products/Drill_Bits.html

The sander is pretty much just like a dreammil with a steel shaft to extend down into the holes. Im sure you may be able to modify existing tools to duplicate its function.