random
could you please tell me how you sharpen a spade bit while it is turning in the lathe,I use a scraping chisel and bore chambers by hand, which is fine but recently I've thought of using a spadebit, but was also aware of both sides being uneven when sharpened by hand
thanks
guide hole for tobacco bit?
- abbeypipes
- Posts: 40
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: england
pipehole
thanks random
yep being careful with 2 flying objects sure would need some care!
thanks again
abbeypipes
yep being careful with 2 flying objects sure would need some care!
thanks again
abbeypipes