Pipe Senatorov " Dublin F "

Senatorov · Post by **Senatorov** » Sat Jan 17, 2009 4:06 pm

Hello. Today has finished here such pipe "Dublin F". Other photos on my site. http://www.senatorov.lv/dmeng.html

Charl · Post by **Charl** » Sun Jan 18, 2009 4:29 am

Nice one!

android · Post by **android** » Sun Jan 18, 2009 10:57 pm

outstanding, i really like this one!

Senatorov · Post by **Senatorov** » Mon Jan 19, 2009 12:47 pm

Thanks, too very much are pleasant to me

pennsyscot · Post by **pennsyscot** » Mon Jan 19, 2009 1:09 pm

Spectacular, as usual. How do you prevent more stain from being absorbed near the end grain?

Senatorov · Post by **Senatorov** » Mon Jan 19, 2009 3:47 pm

pennsyscot wrote:Spectacular, as usual. How do you prevent more stain from being absorbed near the end grain?

Very accurately paper with sand 1200 grit I grind, but it requires skill, it is necessary to train. I have properly understood you?

pennsyscot · Post by **pennsyscot** » Mon Jan 19, 2009 6:22 pm

How do you prevent from getting a dark ring near the plateau, as in the picture below? thanks for your help, Scot

bscofield · Post by **bscofield** » Mon Jan 19, 2009 7:00 pm

pennsyscot wrote:How do you prevent from getting a dark ring near the plateau, as in the picture below? thanks for your help, Scot

are you saying the text in photo LOUDLY

pennsyscot · Post by **pennsyscot** » Mon Jan 19, 2009 11:06 pm

I hope that my post is not misinterpreted. I did not intend to sound obnoxious, just to be clear.

ToddJohnson · Post by **ToddJohnson** » Mon Jan 19, 2009 11:12 pm

pennsyscot wrote:How do you prevent from getting a dark ring near the plateau, as in the picture below? thanks for your help, Scot

I think actually the problem is that you sanded the understain too aggressively removing more than necessary on the bottom 3/4 of the pipe. If you had sanded lightly enough, you would have managed to achieve the same level of contrast you have near the end grain on the whole pipe. This, ultimately, is the goal of contrast staining. Next time try a bit of a lighter hand with a piece of worn out 400 grit wet/dry paper.

Todd

bscofield · Post by **bscofield** » Tue Jan 20, 2009 2:41 pm

pennsyscot wrote:I hope that my post is not misinterpreted. I did not intend to sound obnoxious, just to be clear.

I was just giving you trouble. I have absolutely no problem with the language barrier... it just has to make you laugh sometimes.

Senatorov · Post by **Senatorov** » Thu Jan 22, 2009 4:54 pm

pennsyscot wrote:How do you prevent from getting a dark ring near the plateau, as in the picture below? thanks for your help, Scot

It is necessary accurately отшлифовывать a pipe, but it demands ability.

FredS · Post by **FredS** » Thu Jan 22, 2009 4:57 pm

отшлифовывать literally means to file away or file down, but in this instance I suppose it should be translated as careful sanding.

Senatorov · Post by **Senatorov** » Thu Jan 22, 2009 5:20 pm

FredS wrote:отшлифовывать literally means to file away or file down, but in this instance I suppose it should be translated as careful sanding.

Yes it is correct