Anyone want to split an order of Brad's spoon bits with me?
- Tyler
- Site Supporter
- Posts: 2376
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Farmersville, TX
- Contact:
Anyone want to split an order of Brad's spoon bits with me?
It occurred to me that a way I might be able to get in on the spoon bit run Brad is making is to split the set up with someone.
I'd like a 3/4" bit. Anyone (or any two) want to join my order and buy the 11/64" and 13/64"?
Tyler
I'd like a 3/4" bit. Anyone (or any two) want to join my order and buy the 11/64" and 13/64"?
Tyler
Tyler Lane Pipes
http://www.tylerlanepipes.com
http://www.tylerlanepipes.com
- Tyler
- Site Supporter
- Posts: 2376
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Farmersville, TX
- Contact:
Jamie,
I should have posted earlier, but both bits are spoken for. Sorry!
Thanks for the offer though.
Tyler
I should have posted earlier, but both bits are spoken for. Sorry!
Thanks for the offer though.
Tyler
Tyler Lane Pipes
http://www.tylerlanepipes.com
http://www.tylerlanepipes.com
Re: Anyone want to split an order of Brad's spoon bits with
You must be making a pipe for Folloder's collection of the World's Smallest Smokeable pipes because my draught holes are only slightly larger than this.Tyler wrote:Anyone (or any two) want to join my order and buy the 11/64" and 13/64"?
- Tyler
- Site Supporter
- Posts: 2376
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Farmersville, TX
- Contact:
LOL...yeah that denominator is important.
OK, lets try again:
11/16 and 13/16.
Better?
Tyler
OK, lets try again:
11/16 and 13/16.
Better?
Tyler
Tyler Lane Pipes
http://www.tylerlanepipes.com
http://www.tylerlanepipes.com
I think Adam Davidson said something to me about how his is making a tiny rack for that collection.
John
www.crosbypipes.com
www.crosbypipes.com
Hex! of course! It was right there all the time.jeff wrote:Of course, aren't yours? They're also hexagonal. After three months of crunching numbers and a few simulations through a supercomputer I have finally settled on the ideal engineering for my pipes.ArtGuy wrote:Jeff, your draught holes are slightly larger than 11/64 and 13/64?
John
www.crosbypipes.com
www.crosbypipes.com