I just purchased a Delta Lathe for pipe production. Does anyone have a suggestion for a source, style and model of a chuck to use? I just bought the basic unit, so any other suggestions would be helpful to get me going.
THanks
Jamie Blakley
Chuck for Delta LA 200 Lathe
- achduliebe
- Posts: 729
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/South Carolina
- Contact:
Hey Jamie,
I just bought the very same lathe and my plan is to get the Oneway Talon with #2 jaws and spigot jaws. Here is a link from Woodcraft:
http://www.woodcraft.com/family.aspx?familyid=3971
You will also want to get a nice Jacob's chuck for the tailstock. Here is a link for that also:
http://www.woodcraft.com/family.aspx?familyid=3975
Hope this helps.
I just bought the very same lathe and my plan is to get the Oneway Talon with #2 jaws and spigot jaws. Here is a link from Woodcraft:
http://www.woodcraft.com/family.aspx?familyid=3971
You will also want to get a nice Jacob's chuck for the tailstock. Here is a link for that also:
http://www.woodcraft.com/family.aspx?familyid=3975
Hope this helps.
-Bryan
"You should never fight, but if you have to fight...fight dirty. Kick 'em in the groin, throw a rock at 'em"
www.quinnpipes.com
"You should never fight, but if you have to fight...fight dirty. Kick 'em in the groin, throw a rock at 'em"
www.quinnpipes.com
- achduliebe
- Posts: 729
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/South Carolina
- Contact:
No problem, glad to have hopefully helped you out.
-Bryan
"You should never fight, but if you have to fight...fight dirty. Kick 'em in the groin, throw a rock at 'em"
www.quinnpipes.com
"You should never fight, but if you have to fight...fight dirty. Kick 'em in the groin, throw a rock at 'em"
www.quinnpipes.com