On several occasions I've need a longer 9/64 taper bit and I can't seem to find one.
I drill my draft and stem 9/64", maybe I should rethink this and go to a 11/64" or maybe smaller 5/32"?
I don't want to go much larger but, if the general consensus is to drill ones draft larger I will.
Thank you for any advice.
Where to find a 5" to 6" long 9/64" taper bit?
Where to find a 5" to 6" long 9/64" taper bit?
rdpipes.briar.club
- sandahlpipe
- Posts: 2106
- Joined: Mon Feb 04, 2013 8:49 pm
- Location: Zimmerman, MN
- Contact:
Re: Where to find a 5" to 6" long 9/64" taper bit?
You can find them at McMaster-Carr.
Re: Where to find a 5" to 6" long 9/64" taper bit?
Jamestowne Distributor also sells them
Re: Where to find a 5" to 6" long 9/64" taper bit?
Thank you Wayne, I did find one at Hardwick's a bit cheaper them McMaster-Carr.wdteipen wrote:Jamestowne Distributor also sells them
I've gotten a lot of things from M-C in the past years but learned you better get a good size order or they'll rape you on shipping.
rdpipes.briar.club