Hello guys, about to start trying my hand at pipes. I'm an ABS bladesmith from Alabama and a machinist. Working on following the same advice I give to new knife makers and I'm reading my way through all the pages on the forum. My plan is to get a few pre-drilled blocks so I can concentrate on shaping and finishing a pipe then going on to completely fitting everything up. Other than asking questions I reckon it'll be a few years before I can add anything to the forum. Ears open and mouth shut.
If y'all are interested I'll post some knife pics up so you can get an idea of what kind of work I do. Thanks in advance for y'all tolerating me.
Hiya
-
- Posts: 1056
- Joined: Mon Jan 07, 2013 6:25 pm
Re: Hiya
Welcome will46r, You will have a blast and it's a good plan to read the forum.
- sandahlpipe
- Posts: 2106
- Joined: Mon Feb 04, 2013 8:49 pm
- Location: Zimmerman, MN
- Contact:
Re: Hiya
Welcome! And definitely feel free to share the knife pics on the "Other Stuff We Make" section.