I need vulcanite rod

ScoJo · Post by **ScoJo** » Fri May 27, 2005 10:41 am

Is anyone selling any? Where should I look? I am obsessed with a pipe I found online that I would like to try to recreate (I know it won't look the same, but I'm going to try). Problem is it has a hand-turned stem and a triangular shank. I guess I've resigned myself that this cannot be done with one of my pre-formed stems...

bscofield · Post by **bscofield** » Fri May 27, 2005 12:09 pm

Scott, that guy that sold us our drill bits told me he had vulcanite. You could give him a try and see if he does or not. Let me know what you find out too...

Post by **KurtHuhn** » Fri May 27, 2005 1:05 pm

I'll have some I can spare in a week or so. If you're still looking, ping me then.

Post by **Tyler** » Fri May 27, 2005 2:36 pm

Scott,

I've seen the pipe of which you speak, and I'd bet a dollar it is a preformed stem. I've seen stems exactly like that. Not to disuade you from your hand-cutting efforts, but it is not absoutely necessary in this case.

Tyler

bscofield · Post by **bscofield** » Sat May 28, 2005 10:34 am

ScoJo wrote:I am obsessed with a pipe I found online

Tyler wrote:I've seen the pipe of which you speak

Secrets, secrets are no fun. Secrets, secrets hurt someone!

What's the pipe!?

LexKY_Pipe · Post by **LexKY_Pipe** » Sun May 29, 2005 2:14 pm

Let's see the picture?

pipemakersforum.com

I need vulcanite rod

I need vulcanite rod

Re: I need vulcanite rod